Yupiteru MVT-7100 Manuel d'utilisateur télécharger pdf (Page 16)

Skip

The Skip function is used during scan and search modes to prevent the radio from stopping on any one

frequency for an undue amount of time.

Normally, when scanning or searching comes across an active transmission it will stop on that frequency

until the transmission ceases and then resume scanning/searching. For some situations, staying on one

frequency for too long may miss transmissions occurring on other frequencies.

When the Skip function is enabled, if the scan or search operation stops on an active transmission, it will

resume the scan/search when the transmission ends or five seconds have elapsed; whichever occurs first.

To enable Skip

1. Press FUNC + SKIP

2. The SKIP indicator appears

To disable Skip

1. Press FUNC + SKIP

2. The SKIP indicator disappears

NOTE : The Skip function has no effect on active priority channel signals.

Acknowledgment

Many thanks go to those who have helped me to improve this guide by providing corrections and other

feedback!

Mark Ansel

Last updated June 23, 1999

1 2 ... 11 12 13 14 15 16

Pas de commentaire

Yupiteru MVT-7100 Manuel d'utilisateur Page 16